Removal & Installation - 3.9L

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2001 Mercury Sable, 2001 Mercury Grand Marquis, 2001 Mercury Cougar, 2001 Lincoln Town Car, and 2001 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Crankshaft Position Sensor Component Location - 3.9L

Courtesy of FORD MOTOR CO.

With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
Disconnect the crankshaft position (CKP) sensor electrical connector.
Remove the bolt and the CKP sensor.
- To install, tighten to 10 Nm (89 lb-in).
- Inspect and install a new O-ring seal as necessary.

NOTE: Lubricate the O-ring seal with clean engine oil.

To install, reverse the removal procedure.