Removal & Installation (3.0L VIN U & 2)
WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2001 Mercury Sable, 2001 Mercury Grand Marquis, 2001 Mercury Cougar, 2001 Lincoln Town Car, and 2001 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.
- CMP sensor is located on top of camshaft synchronizer assembly. Disconnect negative battery cable. Remove the accelerator cable shield. Disconnect accelerator cable, speed control actuator cable and throttle return spring from throttle body lever. Remove 2 bolts retaining accelerator cable bracket and position aside. Loosen the clamp and disconnect the hose. Detach the spark plug wire retainer. Detach the wiring harness from the intake manifold support. Release the fuel charging wiring harness from the valve cover studs. Position the wiring harness away from the camshaft position sensor.
- Disconnect CMP sensor harness connector. Remove CMP sensor mounting bolts and CMP sensor. To install, reverse removal procedure. Tighten CMP sensor bolts to specification. See TORQUE SPECIFICATIONS . If camshaft synchronizer removal and installation is necessary, see CAMSHAFT SYNCHRONIZER .