Removal & Installation
WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2001 Mercury Sable, 2001 Mercury Grand Marquis, 2001 Mercury Cougar, 2001 Lincoln Town Car, and 2001 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.
- If removing fuel pressure sensor while fuel injection supply manifold assembly is still installed on engine, release fuel pressure. See FUEL SYSTEM PRESSURE RELEASE . Remove electrical connector (if necessary) and vacuum hose at fuel pressure sensor.
- Disconnect fuel supply line. See FUEL LINE CONNECTOR . Remove 2 fuel pressure sensor mounting bolts. Remove fuel pressure sensor assembly, gasket and discard "O" ring.
- To install, ensure sealing surfaces are clean. Lubricate NEW "O" ring with clean 5W-30 engine oil. Install NEW "O" ring and gasket on fuel pressure sensor. Install fuel pressure sensor on fuel injection supply manifold assembly, and tighten bolts to specification. See TORQUE SPECIFICATIONS .