LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 20 (Engine Controls - Removal & Installation & Overhaul) >> Fuel System >> Fuel Injection Supply Manifold & Injectors >> Removal (LS 3.0L DOHC)

Removal (LS 3.0L DOHC)

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2001 Mercury Sable, 2001 Mercury Grand Marquis, 2001 Mercury Cougar, 2001 Lincoln Town Car, and 2001 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ensure ignition switch is turned to OFF position. Release fuel pressure. See FUEL SYSTEM PRESSURE RELEASE . Remove upper intake manifold. See UPPER INTAKE MANIFOLD . Disconnect fuel charging electrical connector from engine control electrical connector located on rear side of wiring shield behind lower intake manifold.
  2. Disconnect electrical connector and vacuum hose from fuel pressure sensor. Disconnect fuel supply line. See FUEL LINE CONNECTOR . Remove lower intake manifold. See LOWER INTAKE MANIFOLD (3.0L DOHC) .
  3. Place lower intake manifold upside down and remove 4 retaining bolts and fuel injection supply manifold. Disconnect 6 fuel injector electrical connectors. Carefully disengage injectors from fuel injection supply manifold by rocking fuel injector and pulling upward. Place injectors in a clean container. Remove and discard fuel injector "O" rings.
scientia non olet · About LEMON Manuals