Fuel Injection Supply Manifold & Injectors: Installation

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2001 Mercury Sable, 2001 Mercury Grand Marquis, 2001 Mercury Cougar, 2001 Lincoln Town Car, and 2001 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.

Position NEW "O" rings onto fuel injectors. Lightly lubricate "O" rings with clean 5W-30 engine oil. To complete installation, reverse removal procedure. Ensure injectors are properly seated. Tighten fuel injection supply manifold bolts to specification. See TORQUE SPECIFICATIONS .

Position NEW "O" rings onto fuel injectors. Lightly lubricate "O" rings with clean 5W-30 engine oil. To complete installation, reverse removal procedure. Ensure fuel injectors are properly seated. Tighten fuel injection supply manifold bolts to specification. See TORQUE SPECIFICATIONS .

When installing fuel injection supply manifold assembly, use NEW "O" rings. Lubricate "O" rings with clean 5W-30 engine oil. Push fuel injection supply manifold down to ensure all injector "O" rings are fully seated in fuel injection supply manifold cups and lower intake manifold. Install fuel injection supply manifold bolts and tighten to specification. See TORQUE SPECIFICATIONS . To complete installation, reverse removal procedure. Check for leaks when completed.

When installing fuel injection supply manifold assembly, use NEW "O" rings. Push fuel injection supply manifold down to ensure all injector "O" rings are fully seated in fuel injection supply manifold cups and intake manifold. Install fuel injection supply manifold bolts and tighten to specification. See TORQUE SPECIFICATIONS . Reinstall fuel injector retaining clips. To complete installation, reverse removal procedure.

When installing fuel injection supply manifold assembly, use NEW "O" rings. Lubricate "O" rings with clean 5W-30 engine oil. Push fuel injection supply manifold down to ensure all injector "O" rings are fully seated in fuel injection supply manifold cups and intake manifold. Install fuel injection supply manifold bolts and tighten to specification. See TORQUE SPECIFICATIONS . To complete installation, reverse removal procedure. Check for leaks when completed.