LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 197 (Seat System -- F250-F550 Super Duty) >> Removal And Installation >> Seat Control Switch - With Seat Integrated Restraints (SIR) >> Removal

Seat Control Switch - With Seat Integrated Restraints (SIR): Removal

WARNING: This page is about a different car, the 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the affected seat. For additional information, refer to FRONT SEAT - WITH SEAT INTEGRATED RESTRAINTS (SIR)  in this article.
  2. Remove the seat adjuster control knobs, covers and the seat side trim panel screws.
    1. Remove the seat recliner lever cover screw and cover.
    2. Pull to remove the lumbar control knob.
    3. Remove the three seat side trim panel attachment screws.
      Fig 1: Removing Seat Side Trim Panel
      G03925527Courtesy of FORD MOTOR CO.
  3. Remove the two screws securing the lumbar adjuster control to the seat track riser.
    • Push the lumbar adjuster control inward to provide clearance for trim panel removal.
      Fig 2: Removing Screws Securing
      G03925442Courtesy of FORD MOTOR CO.
  4. Pull the rearward lower corner of the side shield to disengage the metal retaining clip.
    5. CAUTION: Bend the side shield slightly to make sure the shield is not scratched by the recliner lever.
  5. Remove the side trim cover.
  6. Disconnect the seat control switch electrical connector.
    Fig 3: Disconnecting Seat Control Switch Electrical Connector
    G03925443Courtesy of FORD MOTOR CO.
  7. Remove the two screws on the seat control switch.
    Fig 4: Removing Screws On Seat Control Switch
    G03925444Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals