Trim Panel - Body Side to Roof Moulding: Removal

WARNING: This page is about a different car, the 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Step one applies to SuperCab and Crew Cab only.

Remove the rear seat. For additional information, refer to SEATING .
Remove the rear safety belt retractor and tongue (611B69). For additional information, refer to SAFETY BELT SYSTEM .
Remove the rear corner trim panel (278D12). For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
Remove the two nuts.

Fig 1: Removing Body Side to Roof Moulding Nuts
Courtesy of FORD MOTOR CO.
Carefully pry the body side-to-roof moulding away from the vehicle body.