Key-In-Ignition Warning Switch: Removal

WARNING: This page is about a different car, the 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Remove the ignition switch lock cylinder.
1. Insert the ignition key and turn it to the RUN position.
2. Insert a punch in the access hole of the steering column and press the release tab while pulling out the ignition switch lock cylinder.
  
  Fig 1: Removing Ignition Switch Lock Cylinder
  Courtesy of FORD MOTOR CO.
Remove the key-in-ignition warning switch.
1. Pry the clip downward.
2. Release the key-in-ignition warning switch from the rear of the ignition switch lock cylinder.
  
  Fig 2: Removing Key-In-Ignition Warning Switch
  Courtesy of FORD MOTOR CO.