DTC P0452: Evaporative Emission System Pressure Sensor/Switch Low
WARNING: This page does not describe the selected car, but rather 32 other vehicles, including the 2011 Mercury Milan, 2011 Mercury Mariner, 2011 Mercury Grand Marquis, 2011 Lincoln Town Car, and 2011 Lincoln Navigator L. However, it is still accessible from the selected car via links, so may be relevant.
P0452 - EVAPORATIVE EMISSION SYSTEM PRESSURE SENSOR/SWITCH LOW
| For Vehicles With NVLD Module | |||
| Description: | The natural vacuum leak detection (NVLD) module monitors the position of the NVLD module pressure switch. This DTC sets if the NVLD module pressure switch voltage is out of range low. | ||
| Possible Causes: |
|
||
| Diagnostic Aids: | |||
| For All Others | |||
| Description: | The powertrain control module (PCM) monitors the evaporative emission (EVAP) control system fuel tank pressure (FTP) sensor input signal to the PCM. The test fails when the signal average drops below a minimum allowable calibrated parameter. | ||
| Possible Causes: |
|
||
| Diagnostic Aids: | An FTP voltage PID reading less than 0.22 volt in key ON, engine OFF or key ON, engine running indicates a concern is present. | ||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| Fiesta | GO to PINPOINT TEST HZ . | ||
| All others | GO to PINPOINT TEST HX . | ||