DTC P0322: Ignition/Distributor Engine Speed Input Circuit No Signal
WARNING: This page does not describe the selected car, but rather 32 other vehicles, including the 2011 Mercury Milan, 2011 Mercury Mariner, 2011 Mercury Grand Marquis, 2011 Lincoln Town Car, and 2011 Lincoln Navigator L. However, it is still accessible from the selected car via links, so may be relevant.
P0322 - IGNITION/DISTRIBUTOR ENGINE SPEED INPUT CIRCUIT NO SIGNAL
| Description: | The ignition engine speed sensor input signal to powertrain control module (PCM) is continuously monitored after one normal camshaft signal is detected and the starter motor is engaged, or the camshaft speed exceeds the equivalent speed of engine idle. The test fails when one or more full camshaft revolutions have elapsed without profile ignition pickup (PIP) pulses. | ||
| Possible Causes: |
|
||
| Diagnostic Aids: | The DTC indicates no PIP pulses occurred while camshafts rotation is measured. | ||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| All | GO to PINPOINT TEST A . | ||