DTC P0011: Intake Camshaft Position Timing - Over-Advanced (Bank 1)

WARNING: This page does not describe the selected car, but rather 32 other vehicles, including the 2011 Mercury Milan, 2011 Mercury Mariner, 2011 Mercury Grand Marquis, 2011 Lincoln Town Car, and 2011 Lincoln Navigator L. However, it is still accessible from the selected car via links, so may be relevant.

P0011 - INTAKE CAMSHAFT POSITION TIMING - OVER-ADVANCED (BANK 1)

Description:	The powertrain control module (PCM) monitors the variable camshaft timing (VCT) position for an over-advanced camshaft timing. The test fails when the camshaft timing exceeds a maximum calibrated value or remains in an advanced position.
Possible Causes:	Camshaft timing incorrectly set Continuous oil flow to the VCT piston chamber Erratic camshaft position due to low oil pressure Oil flow restriction in the oil passages or the VCT valve body VCT solenoid valve stuck open Open or short in the VCT circuit Open VPWR circuit Camshaft advance mechanism binding (VCT unit) Damaged VCT phaser Damaged camshaft position (CMP) sensor Open or short in the CMP sensor circuits Radio frequency interference
Diagnostic Aids:	These DTCs may be accompanied by other DTCs. Diagnose all CMP sensor DTCs first. If no CMP sensor related DTCs are present, continue to follow diagnosis for the DTC. This DTC is a functional check of the VCT unit. Diagnose any base engine concerns related to the engine oil pressure or engine timing. Refer to the appropriate Engine System article, Oil Pressure Test , to check the engine oil pressure. Refer to the appropriate Engine article, Timing Drive Components , to check the engine timing and VCT phasers.
Application	Key On Engine Off	Key On Engine Running	Continuous Memory
All	GO to PINPOINT TEST HK .