Glow Plug Sleeve: Installation

WARNING: This page is about a different car, the 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Verify the glow plug bore is completely clean and dry.
Apply Threadlock 262® sealant to the glow plug sleeve in two places.

Fig 1: Applying Threadlock 262® Sealant To Glow Plug Sleeve
Courtesy of FORD MOTOR CO.
Install the glow plug sleeve into the glow plug bore until it bottoms.

Fig 2: Installing Glow Plug Sleeve Into Glow Plug Bore
Courtesy of FORD MOTOR CO.
Clean the glow plug sleeve after installation with a nylon brush and solvent. Make sure Threadlock 262® sealant is cleaned out before it hardens.
Install the press-in-place gasket.
- Install new dowels in the cylinder head an the gasket.
  
  Fig 3: Locating Gasket
  Courtesy of FORD MOTOR CO.
Position the rocker arm carrier on the cylinder head. Install the bolts.

Fig 4: Rocker Arm Carrier And Bolts - With Torque Specifications
Courtesy of FORD MOTOR CO.
Install the lifting bracket on the cylinder head.
Install the cylinder heads. For additional information, refer to ENGINE - 6.0L DIESEL .