Removal and Installation
WARNING: This page is about a different car, the 2011 Mercury Milan, 2011 Lincoln MKZ, and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
On the MKZ, there is an outer lighted scuff plate. For additional information, refer to SCUFF PLATE TRIM PANEL - FRONT, LIGHTED OUTER .
- Pull the front inboard section of the scuff plate trim panel outward to release the 1 retaining clip.
- Lift the scuff plate trim panel straight up to release the scuff plate trim panel from the 3 retaining clips.
- To install, reverse the removal procedure.
- Align the scuff plate trim panel into the clips and snap into place.
NOTE:
The 3 retaining clips must stay attached to the door weather strip and pinch weld.