Removal and Installation
WARNING: This page is about a different car, the 2011 Mercury Milan, 2011 Lincoln MKZ, and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the C-pillar trim panels. For additional information, refer to C-PILLAR TRIM PANEL in this service information.
- Remove the rear seat bolsters. For additional information, refer to SEAT SYSTEM - SEATS -- FUSION, MILAN & MKZ article.
- Fold the rear seats down.
- Pull the seat back latch covers forward and remove from the vehicle.
- Remove the high mounted stoplamp. For additional information, refer to EXTERIOR LIGHTING -- FUSION, MILAN & MKZ article.
- Remove the 2 pushpins.
- Thread the seat belts through the guides.
- To install, reverse the removal procedure.