Normal Operation
With the ignition switch in the RUN position, voltage is supplied to the rear video camera.
For vehicles without navigation, with the gear selector in REVERSE (R) position, a reverse voltage signal is sent to the auto-dimming interior mirror supplying power to the display in the mirror. The video camera signal is sent to the auto-dimming interior mirror. The video signal from the video camera displays an image on the LH side of the auto-dimming interior mirror.
For vehicles with navigation, with the gear selector in the REVERSE (R) position, a reverse signal is sent from the IPC to the Audio Control Module (ACM) over the Medium Speed Controller Area Network (MS-CAN), enabling the system. The video signal from the video camera displays an image on the Front Display Interface Module (FDIM).
This pinpoint test is intended to diagnose the following:
- Fuse
- Wiring, terminals or connectors
- Video camera
- Auto-dimming interior mirror (without navigation)
- FDIM (with navigation)