LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 176 (Fuel Tank & Fuel Lines -- F250-F550 Super Duty) >> Removal And Installation >> Fuel Tank - Midship >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: Do not smoke or carry lighted tobacco or open flame of any type when working on or near any fuel-related component. Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions can result in personal injury.
WARNING: Fuel in the fuel system remains under high pressure even when the engine is not running. Before repairing or disconnecting any of the fuel system components, the fuel system pressure must be relieved to prevent accidental spraying of fuel, causing personal injury or a fire hazard.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING .
  2. Release the fuel system pressure. For additional information, refer to FUEL SYSTEM-GENERAL INFORMATION - GASOLINE AND DIESEL .
  3. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  4. Drain the fuel from the fuel tank. For additional information, refer to FUEL SYSTEM-GENERAL INFORMATION - GASOLINE AND DIESEL .
  5. Remove the 7 bolts and the fuel tank shield.
    • To install, tighten to 20 Nm (15 lb-ft).
  6. Disconnect the fuel tank filler pipe vent tube quick connect fitting. For additional information, refer to FUEL SYSTEM-GENERAL INFORMATION - GASOLINE AND DIESEL .
  7. Disconnect the fuel vapor tube and fuel supply tube quick connect fittings from the fuel pump module. For additional information, refer to FUEL SYSTEM-GENERAL INFORMATION - GASOLINE AND DIESEL .
  8. Disconnect the fuel vapor tube quick connect fittings from the fuel tank grade vent valves. For additional information, refer to FUEL SYSTEM-GENERAL INFORMATION - GASOLINE AND DIESEL .
  9. Place a suitable lifting device under the fuel tank.
  10. Remove the 3 fuel tank strap bolts and carefully position the 2 fuel tank straps aside.
    • To install, tighten to 40 Nm (30 lb-ft).
  11. Lower the fuel tank.
  12. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals