Glass, Frames and Mechanisms: Notes
WARNING: This page is about a different car, the 2011 Mercury Milan, 2011 Lincoln MKZ, and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The Smart Junction Box (SJB) may also be identified as the Generic Electronic Module (GEM).
The glass, frames and mechanisms consist of:
- accessory delay relay.
- door window regulator motors.
- Front Controls Interface Module (FCIM).
- front door glass top run.
- front door window glass.
- HVAC module.
- rear door window glass.
- rear window defrost grid.
- rear window defrost relay.
- rear window glass.
- rear fixed window glass.
- rear window regulator and motor - run and brackets.
- SJB.
- window control switches.
- window regulators.
- windshield glass.
The glass, frames and mechanisms include:
- standard plastic and laminate safety glass.
- windshield glass which is bonded to the opening flange with a urethane adhesive.
NOTE:
All vehicles are equipped with one-touch up/down feature on the LH front window. All MKZ and some Fusion/Milan vehicles are equipped with one-touch up/down feature for both LH and RH front windows.
The window regulator control switch:
- is located on each door trim panel.
- may be used to manually raise or lower all windows from the left front window control switch or the individual side window from the corresponding individual door switch.
- can lock out rear window control switches when the lock-out switch on the left front window control switch is turned on.
The accessory delay relay, located in the SJB, provides power for the operation of the power windows. The accessory delay feature is active when the ignition switch is in the RUN or the ACC position, or when the ignition switch is changed from RUN or ACC to the OFF/LOCK position and the LF and RF doors are closed.