Removal and Installation
WARNING: This page is about a different car, the 2011 Mercury Milan, 2011 Lincoln MKZ, and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the rear bumper cover. For additional information, refer to BUMPER COVER - REAR in this service information.
- Remove the rear bumper isolator from the rear bumper.
- Pull the isolator rearward to remove it from the retaining pins.
- Remove the 2 rear bumper nuts.
- To install, tighten to 25 Nm (18 lb-ft).
- Remove the 4 rear bumper bolts.
- To install, tighten to 25 Nm (18 lb-ft).
- Remove the rear bumper.
- To install, reverse the removal procedure.