Removal and Installation
WARNING: This page is about a different car, the 2011 Mercury Milan, 2011 Lincoln MKZ, and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the intake manifold. For additional information, refer to ENGINE MECHANICAL - 2.5L -- FUSION HYBRID, MILAN HYBRID & MKZ HYBRID article.
- Release the coolant bypass hose from the clip.
- Remove the 8 bolts and the crankcase vent oil separator and gasket.
- To install, tighten to 10 Nm (89 lb-in).
- To install, reverse the removal procedure.
- Clean the engine block mating surface.