Selector Lever Knob: Installation

WARNING: This page is about a different car, the 2011 Mercury Milan, 2011 Lincoln MKZ, and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

All vehicles

NOTE: It is necessary to route the Transmission Control Switch (TCS) harness or select switch harness through the selector lever bezel when installing the selector lever knob.

NOTE: TCS shown in the illustration, select switch similar.

Fig 1: Locating Selector Lever, Selector Lever Knob And Screws

Courtesy of FORD MOTOR CO.

Install the selector lever knob on the selector lever and install the screws.
Slide the selector lever knob bezel up and install it on the selector lever knob.

Fig 2: Sliding Selector Lever Knob Bezel
Courtesy of FORD MOTOR CO.

Vehicles equipped with 2.5L or 3.0L (4V) engine
Connect the TCS or select switch electrical connector.

Fig 3: Locating Select Switch Electrical Connector
Courtesy of FORD MOTOR CO.
Install the center console trim panel.

Fig 4: Locating Center Console Trim Panel
Courtesy of FORD MOTOR CO.
Install the selector lever trim ring.

Fig 5: Locating Selector Lever Trim Ring
Courtesy of FORD MOTOR CO.