Selector Lever Bezel - MKZ: Installation

WARNING: This page is about a different car, the 2011 Mercury Milan, 2011 Lincoln MKZ, and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

Install the selector lever trim ring in the selector lever bezel.

Fig 1: Locating Selector Lever Trim Ring
Courtesy of FORD MOTOR CO.

NOTE: When installing the selector lever boot, be sure it is in the correct position or the selector lever boot can not be installed on the selector lever knob. If needed, align the selector lever knob to the selector lever boot when installing the boot.

Fig 2: Installing Selector Lever Boot In Selector Lever Bezel

Courtesy of FORD MOTOR CO.

Install the selector lever boot in the selector lever bezel.
Position the selector lever bezel in place and connect the electrical connector.

Fig 3: Locating Selector Lever Bezel Electrical Connector
Courtesy of FORD MOTOR CO.
Position the selector lever bezel in place and install it onto the center console.

Fig 4: Locating Selector Lever Bezel, Center Console
Courtesy of FORD MOTOR CO.
Position the selector lever knob onto the selector lever and install the screws.

Fig 5: Locating Selector Lever Knob, Selector Lever And Screws
Courtesy of FORD MOTOR CO.
Slide the selector lever knob bezel up and install it on the selector lever knob.

Fig 6: Sliding Selector Lever Knob Bezel
Courtesy of FORD MOTOR CO.
Install the LH and RH console finish moldings.

Fig 7: Locating LH And RH Console Finish Moldings
Courtesy of FORD MOTOR CO.