Rain Sensor: Removal

WARNING: This page is about a different car, the 2011 Mercury Milan, 2011 Lincoln MKZ, and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: If reinstalling the original rain sensor, a new lens/bracket service kit (19G382) must be acquired prior to performing this procedure.

On vehicles equipped with a Headlamp Control Module 2 (HCM-2), remove the HCM-2. For additional information, refer to EXTERIOR LIGHTING -- FUSION, MILAN & MKZ article.
On vehicles equipped with only a rain sensor, remove the rain sensor cover.
Disconnect the rain sensor electrical connector.

Fig 1: Locating Rain Sensor Electrical Connector
Courtesy of FORD MOTOR CO.

NOTE: Lightly press the rain sensor against the windshield to relieve the clip tension.

Fig 2: Locating Rain Sensor Retaining Clips

Courtesy of FORD MOTOR CO.

Release the 2 rain sensor retaining clips and remove the rain sensor.