Removal and Installation
WARNING: This page is about a different car, the 2011 Mercury Milan, 2011 Lincoln MKZ, and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the front seat backrest. For additional information, refer to SEAT BACKREST - FRONT in this service information.
- Release all the remaining J-clips attaching the trim cover to the cushion frame.
- Release the hook-and-loop strips, remove the hog rings (if equipped), separate the cushion trim cover from the cushion foam pad and remove.
- To install, reverse the removal procedure.
NOTE:
Trim cover J-clip configurations vary with seat option.
NOTE:
Use care when separating the seat cushion trim cover from the hook-and-loop strip, or the hook-and-loop strip can be torn from the cushion foam pad.