Seat Bolster - Rear: Installation
WARNING: This page is about a different car, the 2011 Mercury Milan, 2011 Lincoln MKZ, and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
- Position the side bolster, align and insert to the latch.
- Align the bolt holes and install the side bolster bolt.
- Tighten to 11 Nm (97 lb-in).
- Install the rear seat cushion. Refer to SEAT CUSHION - REAR in this service information.
NOTE:
Make sure the safety belt webbing is not twisted and the safety belts and buckles are accessible to the occupants.