LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 1720 (Seat System - Seats) >> Diagnosis And Testing >> Seats >> Pinpoint Tests >> Pinpoint Test B: DTCs B106E and B106F >> PINPOINT TEST B: DTCs B106E, B106F

PINPOINT TEST B: DTCs B106E, B106F

WARNING: This page is about a different car, the 2011 Mercury Milan, 2011 Lincoln MKZ, and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: If DTC B106F is present, the fault condition must be corrected prior to installing a new DSM. Failure to correct the fault condition first may cause damage to the new DSM, resulting in a repeat repair.
  1. B1 REVIEW THE DTCs 
    • Review the DTCs from the DSM self-test.
    • Are DTCs B106F and B1342 present? 
    1. Yes  : CORRECT the cause of any other DTCs present. When the other DTCs are corrected, INSTALL a new DSM. REFER to DRIVER SEAT MODULE (DSM)  in this service information. TEST the system for normal operation.
    2. No  : GO to B2  .
  2. B2 REPAIR OTHER DTCs 
    • Repair the cause of any DTCs present, other than DTC B106E. Refer to DTC CHARTS  in this service information.
    • Clear the DTCs.
    • Carry out the DSM self-test.
    • Is DTC B106E still present? 
    1. Yes  : The fault causing the output state to be disabled is still present. REPAIR the cause of the concern. CLEAR the DTCs. REPEAT the self-test.
    2. No  : The system is operating correctly at this time. The concern was caused by a fault in one of the output circuits.
scientia non olet · About LEMON Manuals