LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 1712 (Electronic Engine Controls - 2.5L (Except Hybrid)) >> Removal And Installation >> Cylinder Head Temperature (CHT) Sensor >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2011 Mercury Milan and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Detach the Cylinder Head Temperature (CHT) sensor cover and position aside.
  2. Disconnect the CHT sensor electrical connector.
  3. Remove the CHT sensor.
    • To install, tighten to 12 Nm (106 lb-in).
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals