Removal and Installation
WARNING: This page is about a different car, the 2011 Mercury Milan, 2011 Lincoln MKZ, and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the rear seat bolster. For additional information, refer to SEAT SYSTEM - SEATS -- FUSION, MILAN & MKZ article.
- Disconnect the wheel speed sensor electrical connector.
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING article.
- Using a suitable tool, disconnect the grommet from the body.
- Remove the wheel speed sensor harness nut and bolt.
- To install, tighten to 23 Nm (17 lb-ft).
- Remove the wheel speed sensor bolt and the wheel speed sensor.
- To install, tighten to 23 Nm (17 lb-ft).
- To install, reverse the removal procedure.