LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 1701 (Rear Drive Axle/Differential) >> In-Vehicle Repair >> Stub Shaft Seal >> Installation

Stub Shaft Seal: Installation

WARNING: This page is about a different car, the 2011 Mercury Milan, 2011 Lincoln MKZ, and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Lubricate the new stub shaft seal with grease.
    Fig 1: Installing Stub Shaft Seal Using Front Axle Oil Seal Installer And Adapter Handle
    G06065012Courtesy of FORD MOTOR CO.
  1. Using the Front Axle Oil Seal Installer and Adapter Handle, install the stub shaft pilot bearing housing seal.
  2. Install the halfshaft assembly. For additional information, refer to REAR DRIVE HALFSHAFTS article.
scientia non olet · About LEMON Manuals