Positive Crankcase Ventilation (PCV) Heater Element - 5.4L: Installation
WARNING: This page is about a different car, the 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
- Using a new O-ring seal, install the PCV heater element and the bolt.
- Tighten to 10 Nm (89 lb-in).
- Position the PCV tube and connect the quick release couplings.
- Connect the PCV heater element electrical connector.
- Connect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
NOTE:
Lubricate the O-ring seal with clean engine oil prior to installation.
CAUTION:
Make sure the quick release coupling clicks into place when installing the tube. To make sure that the quick release coupling is fully seated, pull on the tube.
NOTE:
Apply clean engine oil to the end of the tube before connecting the coupling.