LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 17 (Engine - 4.2L V6 - VIN 2) >> Engine Oiling >> Oil Pump >> Reassembly & Installation

Reassembly & Installation

WARNING: This page is about a different car, the 2001 Ford Pickup, 2001 Ford Econoline, 2000 Ford Pickup, and 2000 Ford Econoline. However, it is still accessible from the selected car via links, so may be relevant.
  1. To reassemble, reverse disassembly procedure. Ensure components are installed in original location. To install, prime oil pump by filling inlet opening with oil, and rotating pump shaft until oil emerges from outlet opening.
  2. Install and tighten oil pump-to-front cover bolts to specification. See TORQUE SPECIFICATIONS . To complete installation, reverse removal procedure.
CAUTION: If pump and drive shaft do not seat readily, DO NOT force into position. Realign oil pump hex drive with oil pump drive shaft and reinstall.
scientia non olet · About LEMON Manuals