Removal and Installation

WARNING: This page is about a different car, the 2011 Mercury Milan, 2011 Lincoln MKZ, and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

For Hybrid vehicles, remove the headlamp assembly. For additional information, refer to HEADLAMP ASSEMBLY in this service information.
For non-Hybrid vehicles, remove the 4 pin-type retainers and position the fender splash shield aside.

Fig 1: Locating Fender Splash Shield Pin-Type Retainers
Courtesy of FORD MOTOR CO.
For non-Hybrid vehicles, disconnect the parking/turn lamp electrical connector.
Remove the front parking lamp socket from the headlamp assembly.
- Remove the front parking lamp bulb.
To install, reverse the removal procedure.