LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 1664 (Engine Mechanical - 2.5L (Hybrid)) >> In-Vehicle Repair >> Engine Oil Pressure (EOP) Switch >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2011 Mercury Milan, 2011 Lincoln MKZ, and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING article.
  2. Disconnect the Engine Oil Pressure (EOP) switch electrical connector.
  3. Remove the EOP switch.
    • To install, tighten to 15 Nm (133 lb-in).
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals