LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 1662 (Engine Mechanical - 3.0L (4V)) >> In-Vehicle Repair >> Valve Spring, Retainer, and Seal >> Installation

Valve Spring, Retainer, and Seal: Installation

WARNING: This page is about a different car, the 2011 Mercury Milan and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Lubricate the valve guide with clean engine oil.
    Fig 1: Installing Valve Seal Using Valve Stem Oil Seal Installer
    G07781393Courtesy of FORD MOTOR CO.
  1. Using the Valve Stem Oil Seal Installer, install the new valve seal.
    2. NOTE: If the components are to be reinstalled, they must be installed in their original positions or damage to the engine may occur.
    Fig 2: Remove/Install Key, Retainer And Valve Spring Using Valve Spring Compressor
    G07781394Courtesy of FORD MOTOR CO.
  2. Using the Valve Spring Compressor, install the valve spring, retainer and key.
  3. Install the camshaft roller followers. For additional information, refer to CAMSHAFT ROLLER FOLLOWER  in this service information.
scientia non olet · About LEMON Manuals