LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 1662 (Engine Mechanical - 3.0L (4V)) >> In-Vehicle Repair >> Hydraulic Lash Adjuster >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2011 Mercury Milan and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: During engine repair procedures, cleanliness is extremely important. Any foreign material, including any material created while cleaning gasket surfaces that enters the oil passages, coolant passages or the oil pan, can cause engine failure.
  1. Remove the camshaft roller followers. For additional information, refer to CAMSHAFT ROLLER FOLLOWER  in this service information.
    2. NOTE: Mark the positions of the hydraulic lash adjusters to make sure they are assembled in their original positions.
  2. Remove the hydraulic lash adjusters.
    3. NOTE: Inspect the hydraulic lash adjusters for scoring marks and uneven wear in the bore. Install new lash adjusters if necessary.
  3. To install, reverse the removal procedure.
    • Lubricate the hydraulic lash adjusters with clean engine oil.
scientia non olet · About LEMON Manuals