LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 1662 (Engine Mechanical - 3.0L (4V)) >> In-Vehicle Repair >> Flexplate >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2011 Mercury Milan and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING article.
  2. Remove the transaxle. For additional information, refer to AUTOMATIC TRANSAXLE/TRANSMISSION - 6F35 -- FUSION & MILAN article.
  3. Remove the bolts and the flexplate.
    • To install, tighten to 80 Nm (59 lb-ft).
  4. To install, reverse the removal procedure.
  5. After completing the repairs, use the scan tool to perform the Misfire Monitor Neutral Profile Correction procedure following the on-screen instructions.
scientia non olet · About LEMON Manuals