LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 1662 (Engine Mechanical - 3.0L (4V)) >> In-Vehicle Repair >> Crankshaft Rear Seal >> Installation

Crankshaft Rear Seal: Installation

WARNING: This page is about a different car, the 2011 Mercury Milan and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Clean all sealing surfaces with metal surface prep.
    NOTE: Apply clean engine oil to the seal lip and seal bore before installing the seal.
    Fig 1: Installing Crankshaft Rear Oil Seal Using Crankshaft Rear Main Oil Seal Installer Bolts And Crankshaft Rear Main Oil Seal Installer
    G07781278Courtesy of FORD MOTOR CO.
  1. Using the Crankshaft Rear Main Oil Seal Installer Bolts and the Crankshaft Rear Main Oil Seal Installer, install the crankshaft rear oil seal.
  2. Install the flexplate. For additional information, refer to FLEXPLATE  in this service information.
scientia non olet · About LEMON Manuals