LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 1662 (Engine Mechanical - 3.0L (4V)) >> In-Vehicle Repair >> Crankshaft Pulley >> Removal

Crankshaft Pulley: Removal

WARNING: This page is about a different car, the 2011 Mercury Milan and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING article.
  2. Remove the accessory drive belt. For additional information, refer to ACCESSORY DRIVE - 3.0L (4V) -- FUSION & MILAN article.
  3. Remove the crankshaft pulley bolt and washer.
    • Discard the crankshaft pulley bolt.
  4. Using the 3 Jaw Puller, remove the crankshaft pulley.
    Fig 1: Removing Crankshaft Pulley Using 3 Jaw Puller
    G07781263Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals