LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 1662 (Engine Mechanical - 3.0L (4V)) >> In-Vehicle Repair >> Crankshaft Front Seal >> Installation

Crankshaft Front Seal: Installation

WARNING: This page is about a different car, the 2011 Mercury Milan and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Clean all sealing surfaces with metal surface prep.
  1. Apply clean engine oil to the seal lip and seal bore before installing the seal.
  2. Using the Front Cover Oil Seal Installer and the Crankshaft Vibration Damper Installer, install a new crankshaft front seal.
    Fig 1: Installing Crankshaft Front Seal Using Front Cover Oil Seal Installer And Crankshaft Vibration Damper Installer
    G07781270Courtesy of FORD MOTOR CO.
  3. Install the crankshaft pulley. For additional information, refer to CRANKSHAFT PULLEY  in this service information.
scientia non olet · About LEMON Manuals