LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 164 (Electronic Engine Control System -- Diesel Engine -- F250-F550 Super Duty) >> Removal And Installation >> Manifold Absolute Pressure (MAP) Sensor >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Make sure the ignition switch is in the OFF position prior to working on the electronic engine controls.
  1. Turn the ignition switch to the OFF position.
  2. Disconnect the manifold absolute pressure (MAP) sensor.
    • Disconnect the pressure hose.
    • Disconnect the electrical connector.
      Fig 1: Disconnecting Manifold Absolute Pressure Sensor
      G03908120Courtesy of FORD MOTOR CO.
  3. Remove the mounting screws and the MAP sensor.
    Fig 2: Removing Map Sensor Mounting Screws
    G03908121Courtesy of FORD MOTOR CO.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals