Removal and Installation

WARNING: This page is about a different car, the 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Make sure the ignition switch is in the OFF position prior to working on the electronic engine controls.

Turn the ignition switch to the OFF position.

NOTE: The crankshaft position (CKP) sensor is located underneath the air conditioning compressor.

Fig 1: Removing Bracket Nut With Torque Specifications

Courtesy of FORD MOTOR CO.

Remove the nut and position the positive battery cable and bracket aside.
Remove the bolt and position the battery negative cable aside.

Fig 2: Removing/Installing Battery Negative Cable Bolt With Torque Specifications
Courtesy of FORD MOTOR CO.
Disconnect the CKP sensor electrical connector.

Fig 3: Locating CKP Sensor Electrical Connector
Courtesy of FORD MOTOR CO.
Remove the bolt and the CKP sensor.

Fig 4: Removing/Installing CKP Sensor Bolt With Torque Specifications
Courtesy of FORD MOTOR CO.

NOTE: Apply clean engine oil to the O-ring before installation.

To install, reverse the removal procedure.