Removal & Installation
WARNING: This page is about a different car, the 2010 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
While repairing the power steering system, care should be taken to prevent the entry of foreign material or failure of the power steering components may result.
- Using a suitable suction device, remove the power steering fluid from the reservoir.
- Release the clamps and disconnect the power steering pump supply hose and the return hose.
- Remove the bolt and the power steering fluid reservoir.
- To install, tighten to 12 Nm (9 lb-ft).
- To install, reverse the removal procedure.
- Fill the power steering system. For additional information, refer to GENERAL PROCEDURES article.