Removal & Installation

WARNING: This page is about a different car, the 2010 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.

Remove the front seats. For additional information, refer to SEATING article.
Remove the RH lower A-pillar trim panel.

Fig 1: Identifying RH Lower A-Pillar Trim Panel

Courtesy of FORD MOTOR CO.

Remove the RH front safety belt anchor bolt.
- To install, tighten to 40 Nm (30 lb-ft).

Fig 2: Identifying RH Front Safety Belt Anchor Bolt

Courtesy of FORD MOTOR CO.

Remove the RH lower B-pillar finish panel.

Fig 3: Identifying RH Lower B-Pillar Finish Panel

Courtesy of FORD MOTOR CO.

Position the carpet away from the rear footwell duct.
Detach the wire harness from the rear footwell duct.

Fig 4: Identifying Wire Harness

Courtesy of FORD MOTOR CO.

Remove the rear footwell duct pin-type retainer and the rear footwell duct.

Fig 5: Identifying Rear Footwell Duct Pin-Type Retainer

Courtesy of FORD MOTOR CO.

To install, reverse the removal procedure.