Removal & Installation
WARNING: This page is about a different car, the 2010 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the 2 nuts and the LH and RH wiper pivot arm.
- To install, tighten to 35 Nm (26 lb-ft).
- Remove the cowl panel grille weather seal.
- Remove the 3 RH cowl panel grille retaining clips.
- Remove the RH pin-type retainer.
- Remove the RH cowl panel grille.
- Remove the 4 LH cowl panel grille retaining clips.
- Remove the LH pin-type retainer.
- Position the LH cowl panel grille aside and disconnect the washer hose from the washer nozzle.
- Remove the LH cowl panel grille.
- To install, reverse the removal procedure.
- Adjust the windshield wiper and pivot arm. For additional information, refer to GENERAL PROCEDURES article.