Seat - Front: Installation
WARNING: This page is about a different car, the 2010 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.
- Install the seat in the vehicle.
- While installing, position the center safety belt buckle anchor to the rear inboard mounting area of the seat track and to the seat mounting stud.
- Connect the electrical connectors.
- Install the 2 front seat track-to-floor bolts.
- Tighten to 25 Nm (18 lb-ft).
- Install the 2 front seat track covers.
- Install the inboard seat track-to-floor nut.
- Before installing the rear inboard nut, make sure the center seat safety belt buckle anchor is correctly positioned to the seat track and seat mounting stud.
- Tighten to 80 Nm (59 lb-ft).
- Install the outboard seat track-to-floor nut.
- Tighten to 25 Nm (18 lb-ft).
- Install the 2 front seat track rear covers.
- Repower the SRS. For additional information, refer to GENERAL PROCEDURES article.
NOTE:
Make sure the safety belt webbing is not twisted and the safety belts and buckles are accessible to the occupants.