Removal And Installation
WARNING: This page is about a different car, the 2010 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the 2 pin-type retainers and the luggage compartment scuff plate.
- Position the luggage compartment trim panel aside.
- Remove the 3 nuts and the rear lamp assembly.
- Remove the bulb sockets from the rear lamp assembly.
- To install, tighten to 7 Nm (62 lb-in).
- To install, reverse the removal procedure.
NOTE:
For the LH rear lamp on vehicles equipped with THX®, remove the audio amplifier. For additional information, refer to INFORMATION & ENTERTAINMENT SYSTEMS
article.