Differential Housing Cover: Installation

WARNING: This page is about a different car, the 2010 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: The machined surfaces on the differential housing and the differential housing cover must be clean and free of oil before applying the silicone sealant. Cover the inside of the rear axle prior to cleaning the machined surface to prevent contamination.

Clean the gasket mating surfaces.

NOTE: Install the differential housing cover within 15 minutes of applying the silicone or it will be necessary to apply new sealant.

Apply a continuous bead of silicone gasket and sealant to the differential housing cover.

Fig 1: Applying Sealer To Cover

Courtesy of FORD MOTOR CO.

NOTE: If possible, allow at least one hour before filling the axle with lubricant to allow the silicone sealant to cure.

Install the differential housing cover.
1. Position the differential housing cover.
2. Install the 10 bolts.
  - Tighten the bolts in a star pattern.
  - Tighten to 45 Nm (33 lb-ft).

Fig 2: Removing Differential Housing Cover

Courtesy of FORD MOTOR CO.

NOTE: For Traction-Lok® axles, first fill the rear axle with 118 ml (4 oz) of additive friction modifier.

NOTE: Before attempting to remove the axle fill plug, make sure the tool recess is free of foreign material which may keep the tool from fully engaging the plug. Clean the recess with a small screwdriver or similar tool. Make sure the tool can be fully inserted into the recess before attempting to remove the plug.

NOTE: Service refill capacities are determined by filling the rear axle with the specified lubricant to the level shown in the illustration.

Fill the rear axle with 2.37L (5.0 pt) of lubricant and install the fill plug.
- Tighten to 30 Nm (22 lb-ft).

Fig 3: Rear Axle Fill Level (With Specifications)

Courtesy of FORD MOTOR CO.