Removal and Installation
WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the 2 wiper pivot arms nuts.
- To install, tighten to 35 Nm (26 lb-ft).
- Remove the LH and RH wiper pivot arms.
- Remove the LH and RH cowl end cap pushpin retainers.
- Remove the cowl end caps.
- Release the cowl panel grille from the retaining clips and remove the cowl panel grille.
- To install, reverse the removal procedure.
- Adjust the wiper pivot arms. For additional information, refer to GENERAL PROCEDURES .