Removal and Installation
WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
- Using a suitable tool, (such as a flat-blade screwdriver), gently pry the retaining tabs and remove the parking aid sensor(s).
- Disconnect the electrical connectors.
- To install, reverse the removal procedure.
- Using the scan tool, verify that the parking aid sensor PIDs read no object present and that the parking aid sensor attenuation PIDs read between 0.8-1.6 ms.
- Carry out the azimuth and elevation system check to verify the sensor(s) are operating correctly. For additional information, refer to AZIMUTH SYSTEM CHECK and ELEVATION SYSTEM CHECK .