LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 1548 (Windows And Glass - Glass, Frames And Mechanisms) >> Removal And Installation >> Window Glass - Front Door >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front door trim panel. For additional information, refer to DOOR TRIM PANEL -- FRONT .
  2. Remove the screw and the door trim panel bracket.
  3. Remove the 3 pushpins and pad assembly.
    Fig 1: Locating Pad Assembly And Pushpins
    G06099760Courtesy of FORD MOTOR CO.
  4. Position the watershield aside.
  5. Remove the interior door glass weatherstrip.
  6. Connect the window control switch electrical connector.
  7. Using the window control switch, lower the front door window glass to gain access to the front door window glass screws.
  8. Disconnect the window control switch electrical connector.
  9. Remove the 2 front door window glass screws.
    • To install, tighten to 5 Nm (44 lb-in).
      Fig 2: Locating Front Door Window Glass Screws
      G06099761Courtesy of FORD MOTOR CO.
  10. Remove the front door window glass.
  11. To install, reverse the removal procedure.
    • Cycle the front door window glass to make sure it is engaged correctly.
scientia non olet · About LEMON Manuals