LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 1540 (HVAC - Climate Control System) >> Removal And Installation >> Air Conditioning (A/C) Pressure Relief Valve - 2.5L, 3.0L (4V) >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING -- ESCAPE, ESCAPE HYBRID, MARINER & MARINER HYBRID .
  2. Recover the refrigerant. For additional information, refer to AIR CONDITIONING (A/C) SYSTEM RECOVERY, EVACUATION AND CHARGING .
  3. Remove the A/C pressure relief valve and O-ring seal.
    • To install, tighten to 10 Nm (89 lb-in).
    4. NOTE: A new O-ring seal will already be installed on the new A/C pressure relief valve service part.
  4. To install, reverse the removal procedure.
    • Add the correct amount of clean PAG refrigerant oil to the refrigerant system. For additional information, refer to REFRIGERANT OIL ADDING .
  5. Evacuate, leak test and charge the refrigerant system. For additional information, refer to AIR CONDITIONING (A/C) SYSTEM RECOVERY, EVACUATION AND CHARGING .
scientia non olet · About LEMON Manuals